Elliptical wound tension and HEMIGARD™

SUTUREGARD® Medical, Inc. Blog


Elliptical wound tension and HEMIGARD™

Tension and Healing

Usually, excisional wounds are created with an ellipse: where the length of the wound is about 2-4 times longer than the width. This allows the wound to be closed without “bunching” of the ends.

When closing these elliptical wounds, the initial suture is usually placed in the middle, widest and most difficult portion of the wound to close. This is known as the rule of halves:

Diagram of rule of halves

It is well-known to surgeons that the initial suture is under more tension than subsequent sutures. However, how much more force does the middle suture bear than the “2nd and 3rd sutures”? Myself and two colleagues sought to answer that question. We took elliptical wounds of the trunk and measured the initial force required to close the middle of the wound. Then, we measured the force required for the next two sutures. We discovered that the initial suture bears over five times more force than either of the subsequent two sutures. In many cases, we had difficulty even measuring the small forces involved in sutures placed after the initial suture. We went on to then place and measure tensions of sutures placed after the third suture, but all the forces were all too small for our tensiometer to measure.

This has implications for wound closure, in that the initial, middle suture or staple used to close the wound bears the vast majority of the wound tension.

Given this data, we are very excited by our initial results with the HEMIGARD™ adhesive retention device (ARD). The amount of force that can be used to close a wound is often limited by the strength of the skin itself. The HEMIGARD™ ARD allows large tension suture to be used as the initial suture to get wound closure. Once the skin is apposed with one or more pairs of HEMIGARD™ ARDs, the rest of the wound can be closed with very low tension sutures in a multitude of ways.

For example, we recently had a 3.0 cm wide forehead wound that could not be approximated.

HEMIGARD™ adhesive retention device (ARD) to close a large forehead wound under tension

We used a HEMIGARD™ ARD to bolster the skin on each side of the wound, then used a 0 nylon (THICK) suture to get the edges touching. This HEMIGARD™ ARD and the suture are bearing all that middle (1st suture) tension. This allowed us to perform a standard elliptical excision rather than a flap or graft. The rest of the wound, consistent with our study, was under minimal tension so could be closed with 5-0 (thin and delicate) absorbable sutures and then steri-strips on top. At one week post-op, there was a small imprint from the HEMIGARD™ ARD, but otherwise excellent healing. The patient noted that the “tight” feeling subsided in first day or so after surgery.

We use the HEMIGARD™ ARD routinely to close a wide range of wounds of the legs, arms and face in which the thickness and strength of the skin is limiting our ability to use a high tension suture. How can the HEMIGARD™ ARD help you?




Skin Flap Alternatives

We have previously discussed skin grafts and flaps (link to those posts). The major distinction in a...

Read More >

What is Moh's Surgery?

Mohs surgery relies on processing tissue. The tumor is removed but then it is studied & laid down to...

Read More >

Low Tension Healing: The Future of Scar Surgery

How many times have you done an elliptical excision, and the postoperative scar result is widened at...

Read More >

Reducing the Impact of Pretibial Lacerations

Thin fragile skin can occur with age, severe sun damage or chronic steroid use. Often, they are on b...

Read More >

Are Scalp Repairs Slowing You Down?

Skip the scalp flap or graft with the SUTUREGARD® Rapid Interaoperative Tissue Expansion (RITE) Devi...

Read More >

Relax & Close, More Wounds, More Simply.

Making wound closure easier for surgeons and better for patients.

Contact Us